Putting On The Heart Rate Monitor - Garmin EDGE 1030 PLUS Owner's Manual

Putting On the Heart Rate Monitor

NOTE: If you do not have a heart rate monitor, you can skip this task.
You should wear the heart rate monitor directly on your skin, just below your sternum. It should be snug enough
to stay in place during your activity.
1 Snap the heart rate monitor module
The Garmin logos on the module and the strap should be right-side up.
2 Wet the electrodes
between your chest and the transmitter.
3 Wrap the strap around your chest, and connect the strap hook
NOTE: The care tag should not fold over.
The Garmin logos should be right-side up.
4 Bring the device within 3 m (10 ft.) of the heart rate monitor.
After you put on the heart rate monitor, it is active and sending data.
TIP: If the heart rate data is erratic or does not appear, see the troubleshooting tips
Data, page 39).
38
onto the strap.
and the contact patches on the back of the strap to create a strong connection
to the loop .
(Tips for Erratic Heart Rate
Wireless Sensors