Network Setting (Network) - JRC JMA-5312-6HS Installation Manual

3.21.2 Network Setting (Network)

If you want to change the IP address, please take care to
avoid overlap of IP address. These IP addresses are used
on JMA-9100 series, JMA-7100 series and JMA-5300MK2
series radar. Otherwise the network function is not
available on not only radar but also other equipments.
1) Network Function Setting (Network Function)
Turning on/off the network function.
1) Press and hold [RADAR MENU] key.
The Code Input menu will appear.
2) Press the [0] key, and put the cursor on the
The Serviceman Menu will appear.
3) Open the Baud Rate menu by performing the following menu operation.
2. Installation Menu
4) Set the Network for the item 1. Network Function in the menu.
On
Off
2) IP Address Setting (IP Address)
1) Press and hold [RADAR MENU] key.
The Code Input menu will appear.
2) Press the [0] key, and put the cursor on the
The Serviceman Menu will appear.
3) Open the IP Address Setting menu by performing the following menu operation.
2. Installation Menu
4) Enter the IP address.
IP setting table.
No.1 Radar
No.2 Radar
No.3 Radar
No.4 Radar
All manuals and user guides at all-guides.com
CAUTION
→ 9. Next
→ 4. Network
: The network function is operated.
: The network function is stopped.
→ 9. Next
→ 4. Network
→ 2. IP Address
192.168. 60. 11
192.168. 60. 17
192.168. 60. 23
192.168. 60. 29
3-45
ENT button, and press the [ENT] key.
ENT button, and press the [ENT] key.