JRC JMA-5312-6HS Installation Manual page 110

[Ⅲ] baud rate setting(Baud Rate(BPS))
This setting is enabled when beacon frequency mode is set to manual.
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the Baud Rate menu.
2. Select the baud rate.
Following baud rate is selectable
50bps/100bps/200bps
3. Press the [5] key to send the setting value to DGPS receiver.
[Ⅳ] DGPS Mode setting(DGPS Mode)
When DGPS mode set to on, DGPS use the information from beacon to get reliable position.
When DGPS mode set to off, the accuracy of position is same as GPS.
Procedures 1. Press the [RADAR MENU] key twice, and then perform the following
menu open procedure to open the DGPS Mode menu.
2. Press [4] key to select the DGPS Mode.
3. Press the [5] key to send the setting value to DGPS receiver.
All manuals and user guides at all-guides.com
4. NAV equipment Setting
→ 4. GPS Setting
→ 2. DGPS Setting
→ 3. Baud Rate(BPS)
4. NAV equipment Setting
→ 4. GPS Setting
→ 2. DGPS Setting
On : DGPS use the information from beacon
Off : DGPS don't use the information from beacon
4-25