Link Integrity Commands - SMC Networks EliteConnect SMC2552W-G2 User Manual

known to be already authenticated, so it proceeds directly to key exchange
and association.
• To support pre-authentication, both clients and access points in the network
must be WPA2 enabled.
• Pre-authentication requires all access points in the network to be on the
same IP subnet.
Example
Enterprise AP(if-wireless g: VAP[0])#wpa-pre-shared-key ASCII agoodsecret
Enterprise AP(if-wireless g: VAP[0])#

Link Integrity Commands

The access point provides a link integrity feature that can be used to ensure that
wireless clients are connected to resources on the wired network. The access point
does this by periodically sending Ping messages to a host device in the wired
Ethernet network. If the access point detects that the connection to the host has
failed, it disables the radio interfaces, forcing clients to find and associate with
another access point. When the connection to the host is restored, the access point
re-enables the radio interfaces.
Command
link-integrity ping-detect
link-integrity ping-host
link-integrity ping-interval
link-integrity ping-fail-retry
link-integrity ethernet-detect
show link-integrity
Table 7-20. Link Integrity Commands
Function
Enables link integrity detection
Specifies the IP address of a host device in the
wired network
Specifies the time between each Ping sent to the
link host
Specifies the number of consecutive failed Ping
counts before the link is determined as lost
Enables integrity check for Ethernet link
Displays the current link integrity configuration
Link Integrity Commands
Mode
GC
GC
GC
GC
GC
Exec
7
Page
7-125
7-125
7-126
7-126
7-126
7-127
7-123