SMC Networks EliteConnect SMC2552W-G2 User Manual page 100

CLI Commands for Radio Settings – From the global configuration mode, enter the
interface wireless g command to access the 802.11g radio interface. From the
802.11g interface mode, you can access radio settings that apply to all VAP
interfaces. Use the turbo command to enable this feature before setting the radio
channel with the channel command. Set any other radio setting as required before
enabling the VAP interface (with the no shutdown command). To view the current
802.11g radio settings for the VAP interface, use the show interface wireless g
[0~3] command as shown on
Enterprise AP(config)#interface wireless g
Enter Wireless configuration commands, one per line.
Enterprise AP(if-wireless g)#super-g
Enterprise AP(if-wireless g)#channel 42
Enterprise AP(if-wireless g)#transmit-power full
Enterprise AP(if-wireless g)#speed 9
Enterprise AP(if-wireless g)#antenna id 0000
Enterprise AP(if-wireless g)#antenna control right
Enterprise AP(if-wireless g)#antenna location indoor
Enterprise AP(if-wireless g)#mic_mode hardware
Enterprise AP(if-wireless g)#super-g
Enterprise AP(if-wireless g)#beacon-interval 150
Enterprise AP(if-wireless g)#beacon-interval 150
Enterprise AP(if-wireless g)#dtim-period 5
Enterprise AP(if-wireless g)#multicast-data-rate 6
Enterprise AP(if-wireless g)#fragmentation-length 512
Enterprise AP(if-wireless g)#rts-threshold 256
Enterprise AP(if-wireless g)#
7-95.
6
Radio Interface
7-88
7-104
7-97
7-97
7-96
7-100
7-99
7-101
7-120
7-104
7-101
7-101
7-102
7-96
7-102
7-103
6-53