Table of Contents
Advertisement
Quick Start Guide
Certification
Certification
Certification
Waste
EEUP
Safety Requirements
Warning
Preparation
before use
Check all
terminal rated
values
Use the power
cord properly
Instrument
grounding
AC power
supply
Electrostatic
prevention
Instruments.uni-trend.com
of power station, power instrument, front-end overload protection, and any
outdoor transmission line.
CE indicates a registered trademark of EU
UKCA indicates a registered trademark of United Kingdom.
Conforms to UL STD 61010-1, 61010-2-030, Certified to CSA STD C22.2 No.
61010-1, 61010-2-030.
Do not place equipment and its accessories in the trash. Items must be properly
disposed of in accordance with local regulations.
This environment-friendly use period (EFUP) mark indicates that dangerous or
toxic substances will not leak or cause damage within this indicated time
period. The environment-friendly use period of this product is 40 years, during
which it can be used safely. Upon expiration of this period, it should enter the
recycling system.
Please connect this device to AC power supply with the power cable provided;
The AC input voltage of the line reaches the rated value of this device. See the product
manual for specific rated value.
The line voltage switch of this device matches the line voltage;
The line voltage of the line fuse of this device is correct.
Do not used to measure MAINS CIRCUIT.
Please check all rated values and marking instructions on the product to avoid fire and
impact of excessive current. Please consult the product manual for detailed rated
values before connection.
You can only use the special power cord for the instrument approved by the local and
state standards. Please check whether the insulation layer of the cord is damaged or
the cord is exposed, and test whether the cord is conductive. If the cord is damaged,
please replace it before using the instrument.
To avoid electric shock, the grounding conductor must be connected to the ground.
This product is grounded through the grounding conductor of the power supply. Please
be sure to ground this product before it is powered on.
Please use the AC power supply specified for this device. Please use the power cord
approved by your country and confirm that the insulation layer is not damaged.
This device may be damaged by static electricity, so it should be tested in the
anti-static area if possible. Before the power cable is connected to this device, the
internal and external conductors should be grounded briefly to release static electricity.
UTS1000B/T Series
12 / 18
Advertisement
Table of Contents
