After Finishing Work; Connecting And Charging Usb Device; Transporting; Storing - Stihl AR 2000 L Instruction Manual

12 After Finishing Work

► Hold connecting cable plug (1) so that the
arrow on its side lines up with the arrow point
on the AP adapter's socket (2).
► Insert the connecting cable plug (1) in the
socket (2) on the AP adapter (3).
► Push AP adapter (3) into the battery compart‐
ment (4).
11.3 Connecting battery to a STIHL
cordless product for STIHL AR
L batteries
► Connect the battery as described in the
instruction manual supplied with the cordless
product.
11.4 Disconnecting the battery
► Switch off the cordless product.
► If you are using a cordless product with a
socket: Connect the battery as described in
the instruction manual supplied with the cord‐
less product.
► If you are using an AP adapter: Take the AP
adapter out of the battery compartment.
► If you are using a cordless product for STIHL
AR L batteries: Disconnect the battery as
described in the instruction manual supplied
with the cordless product.
12 After Finishing Work
12.1 After Finishing Work
► Switch off the cordless product.
► Disconnect the battery.
► If the battery, carrying system, connecting
cable or AP adapter is dirty or wet: Clean the
battery, carrying system, connecting cable or
AP adapter and allow to dry.
► Clean the battery, carrying system, connecting
cable and AP adapter.
13 Connecting and Charging
USB Device
13.1 Connecting and Charging USB
Device
1
0458-820-9901-A
► Pull out the dust cap (1).
► Insert the plug (2) in the USB port (3).
► Press the button (4).
The USB cable must be unplugged before start‐
ing work. The dust plug (1) protects the USB port
(3) from moisture and dirt.

14 Transporting

14.1
► Switch off the cordless product.
► Disconnect the battery.
► Check that the battery is in a safe condition.
► Carry the battery on your back or by the han‐
► If the battery is transported in a vehicle:
► If the battery is to be packaged: Package the
The battery is subject to the Carriage of Danger‐
ous Goods regulations. The battery is classified
as UN 3480 (lithium ion batteries) and has been
tested pursuant to UN Manual Tests and Criteria
Part III, Subsection 38.3.
The transport regulations can be found at
www.stihl.com/safety-data-sheets.

15 Storing

15.1
4
3
STIHL recommends keeping the battery in a
charging state between 30% and 45 % (2 green
LEDs lit).
2
USB device is being charged. If the USB
device is not being charged, the charging cur‐
rent supplied by the battery is too low,
The USB device cannot be charged.
Transporting the Battery
dle.
Secure the battery so that it cannot move.
battery in such a way that it cannot move
inside its packaging and secure the packaging
in such a way that it cannot move.
Storing the Battery
English
19.1.
11