Troubleshooting; Specifications - Stihl AR 2000 L Instruction Manual

18 Troubleshooting

18 Troubleshooting
18.1 Troubleshooting the Battery or Cordless Product
Fault LEDs and
Beeps
Cordless product 1 LED flashes
does not run green and 6
after switch-on or long beeps
cuts out during sound.
operation.
1 LED emits
red light.
3 LEDs flash
red.
3 LEDs light up
red.
4 LEDs flash
red and short
beeps sound in
quick succes‐
sion.
Runtime of cord‐
less product is
too short.
Charge process 1 LED emits
does not start red light.
when AP adapter
is inserted in the
charger.

19 Specifications

19.1 STIHL AR 2000 L, 3000 Bat‐
tery
– Battery technology: lithium-ion
– Voltage: 36 V
– Capacity in Ah: see rating label
– Energy content in Wh: see rating label
– Permissible temperature range for operation
and storage: -10°C to 50°C
– Weight in kg: See rating label
– USB port: Plug type A
0458-820-9901-A
Cause
State of charge of the
battery is too low.
The battery is too
warm or too cold.
There is a malfunction
in the battery.
Cordless product too
hot.
There is a fault in the
battery.
No electrical contact
between cordless
product and battery.
Cordless product or
battery damp.
The battery is not fully
charged.
The battery service
life has been excee‐
ded.
The battery is too
warm or too cold.
– BC1.2 (DCP)
– Output voltage: 5 V
– Maximum charging current:1.5 A
19.2
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
Remedy
► Recharge the battery fully as described
in this user manual and in the user man‐
ual for the STIHL AL 301, 301-4 and AL
500 chargers.
► Disconnect the battery.
► Allow the battery to cool down or warm
up.
► Disconnect battery and reconnect.
► Switch on the cordless product.
► If 3 LEDs continue to flash red: Contact
your STIHL servicing dealer for assis‐
tance.
► Disconnect the battery.
► Wait for cordless product to cool down.
► Take the battery off your back.
► Disconnect battery and reconnect.
► Switch on the cordless product.
► If 4 LEDs continue to flash red and short
beeps sound in quick succession: Do not
use or transport the battery, contact your
STIHL servicing dealer.
► Disconnect battery and reconnect.
► If the cordless product still does not run
when switched on or cuts out during
operation: Clean contacts of the con‐
necting cable.
► Allow cordless product / battery to dry.
► Fully charge the battery as described in
the user manual for the STIHL AL 301,
301-4 and 500 chargers.
► Replace battery.
► Leave AP adapter in the charger.
Charging starts automatically as soon as
the permitted temperature range is
reached.
REACH
English
13