After Finishing Work; Transporting; Storing; Cleaning - Stihl AHK 800.0 Instruction Manual

9 After Finishing Work

► Tighten lock nuts (1) firmly.
The working angle is increased.
8.3 Adjusting the Working Width
The working width of the ridger can be adjusted
to five levels.
► Stop the engine.
► Place the tiller on a level surface.
► Lift catches (1).
► Adjust ridger wings (2) so catches (1) can be
hooked into a bore.
► Allow catches (1) to engage.
The ridger wings are adjusted.
8.4 Adjusting the Working Depth
The working depth of the ridger can be adjusted
to four levels.
► Stop the engine.
► Place the tiller on a level surface.
► Detach retaining pin (1) and remove pin (2).
► Adjust ridger (3) so the bores in bracket (4)
and adapter (5) align.

14 Troubleshooting

14.1 Remedying Ridger Faults
Fault
Excessive vibration
during operation.
0478-906-9911-B
Cause
Ridger fastening
loose.
► Insert pin (2).
► Push retaining pin (1) through the bore in
pin (2).
The ridger is locked in place and the working
depth is adjusted.
9 After Finishing Work
9.1 After Finishing Work
► Stop the engine.
► Remove the ridger.
► If the ridger is wet: allow the ridger to dry.
► Clean the ridger.

10 Transporting

10.1 Transporting the Ridger
► Stop the engine.
► Remove the ridger.

11 Storing

11.1 Storing the Ridger
► Stop the engine.
► Remove the ridger.
► Store the ridger in accordance with the follow‐
ing conditions:
– The ridger is out of reach of children.
– The ridger is clean and dry.

12 Cleaning

12.1 Cleaning the Ridger
► Stop the engine.
► Remove the ridger.
► Clean the ridger with a damp cloth or STIHL
resin solvent.
► Clean the catch of the ridger with a paintbrush
or a soft brush.

13 Maintenance and Repairs

13.1 Maintaining and Repairing the
Ridger
The ridger does not need to be maintained and
cannot be repaired.
► If the ridger is defective or damaged: have the
ridger replaced by a STIHL specialist dealer.
Remedy
► Check the connection elements.
English
15