Roland VC-200HD Owner's Manual page 22

Connecting
5. Press the VALUE/ENTER knob.
DDC writing starts. The display shows the following. Do not unplug the DVI cable while this
screen is displayed. After writing is completed, "COMPLETED RESTART THE VC" is shown.
Restart the VC-300HD/VC-200HD.
After the VC-300HD/VC-200HD restarts, the DDC setting change is complete.
Converting DVI-I to HD-SDI (SD-SDI)
Perform the settings on the previous page, and connect the HD video device to the HD-SDI
OUT connector. The selection made in Step 6 determines the format of the video that is
output. Set this item according to the connected device.
* When changing the output video frame rate, please select an appropriate value in step 6.
* Refer to the user's manual that came with your HD video equipment to find out which video
formats it supports.
* When "SD" is used in Step 6, SD-SDI is output. When converting to PAL, select "576/50i" in
step 6. For NTSC, select "480i/60."
Converting DVI-I to Component
Perform the settings on the previous page, and connect the HD video device to the
COMPONENT OUTPUT connector. The selection made in Step 6 determines the format of
the video that is output. Set this item according to the connected device.
* When changing the output video frame rate, please select an appropriate value in step 6.
* Refer to the user's manual that came with your HD video equipment to find out which video
formats it supports.
* When "SD" is used in Step 6, SD component is output. When converting to PAL, select "576/
50i" in step 6. For NTSC, select "480i/60."
Converting DVI-I to DV
By using the scaling feature of the VC-300HD/VC-200HD, DVI-I can be down-converted to
SD video as well as converted to DV.
Perform the settings on the previous page, and connect the DV device to the i.LINK
connector. Select "SD" in Step 6.
* When converting to PAL, select "576/50i" in step 6. For NTSC, select "480i/60."
Converting DVI-I to SD Video
By using the scaling feature of the VC-300HD/VC-200HD, DVI output can be down-converted
to SD video.
Perform the settings on the previous page, and connect the SD video device to the
COMPONENT OUTPUT connector. Select "SD" in Step 6.
* When converting to PAL, select "576/50i" in step 6. For NTSC, select "480i/60."
Converting DVI-I
The DVI-I output with the VC-300HD/VC-200HD is converted to the video format selected with
Step 6. The output video format is as shown below.
Digital (RGB):
Analog (Y/Pb/Pr):
22
1080/59.94p, 1080/50p, 1080/59.94i, 1080/50i, 720/59.94p, 720/50p,
480/59.94p, 576/50p, 480/59.94i, 576/50i
1080/59.94p, 1080/50p, 1080/59.94i, 1080/50i, 720/59.94p, 720/50p,
480/59.94p, 576/50p, 480/59.94i, 576/50i