Table of Contents
Advertisement
6
Select the output format.
6-1. Press the OUTPUT button until "300: Video Out Format" is shown in the display.
6-2. Use the VALUE/ENTER knob to select "1080/59.94i," "1080/50i," "720/59.94p," or "720/50p."
6-3. Press the VALUE/ENTER knob to confirm the selection. The video signal is output in the selected
video format.
Changing the DVI-I INPUT Connector DDC Settings
The DVI-I INPUT connector DDC settings can be changed with the following procedure.
* The input format selection cannot be fixed. "AUTO" is shown for all displays.
1. Connect the DVI-I INPUT connector on the VC-300HD (VC-200HD) to the DVI-I
OUTPUT connector.
2. Start the VC-300HD /VC-200HD in overwrite mode by holding down the
"INPUT" and "PROCESSING" buttons while turning on power.
INPUT button
PROCESSING button
3. Press the VALUE/ENTER knob.
Please wait as the VC-300HD/VC-200HD checks the connection status of the DVI-I connector.
4. Turn the VALUE/ENTER knob to select a setting.
The VC-300HD/VC-200HD display shows "SELECT REFRESH RATE." Use the VALUE/ENTER
knob to select the setting appropriate for the device being used.
Settings on the SELECT
REFRESH RATE screen
Initialize
59.94p / 59.94i
50p / 50i
VALUE/ENTER knob
DDC settings that are set
VESA Format
1080/59.94i, 1080/50i
VESA Format
1080/59.94i, 1080/59.94p, 720/59.94p
VESA Format
1080/50i, 1080/50p, 720/50p
Connecting
If the aspect ratios of the video
selected in step 5. and the
output format selected in step
6. are different, select the
scaling type with "200: Scaling
Type" (p. 37) from the Menu
(p. 32).
If the DVI cable is not properly
connected, the VC-300HD/VC-
200HD Display shows "DVI IS
NOT CONNECTED." Please
check the connection. Once
properly connected, press
VALUE/ENTER to check the
DVI cable connection status
again.
21
Advertisement
Table of Contents
