Roland MV-8000 Owner's Manual page 67

4
Turn the Multi Timbre Sampler Mode parameter On in the MIDI screen.
With this setting, your playing on the velocity pads will be transmitted from the MIDI
OUT connector.
5
Set the Pad Tx Channel parameter.
This specifies the MIDI OUT connector and channel used to transmit your playing on
the velocity pads.
Range Explanation
A- 1 Transmit a MIDI data from MIDI OUT A, channel 1.
: :
A-16 Transmit a MIDI data from MIDI OUT A, channel 16.
B- 1 Transmit a MIDI data from MIDI OUT B, channel 1.
: :
B-16 Transmit a MIDI data from MIDI OUT B, channel 16.
R- 1 Transmit a MIDI data from R-BUS, channel 1.
: :
R-16 Transmit a MIDI data from R-BUS, channel 16.
6
Press .
SEQUENCE screen will appear.
7
Start recording on your external sequencer, and play the velocity pads.
Your velocity pad performance will be recorded on the external sequencer.
Using the MV-8000 with external devices
You can set the Pad Tx
Channel parameter only if
Multi Timbre Sampler Mode is
on.
Value R- 1–R-16 is displayed
when MV8-OP1 is installed.
Your playing on the velocity
pads can be transmitted as
MIDI data while the following
screens are displayed.
• SEQUENCE screen
• EFFECTS screen
• MIXER screen
67