Roland MV-8000 Owner's Manual page 11

REC Parameter
button
Song Position Bar
fig.transport-block2
Mixdown Mode
button
Sync Mode button
Current Time
Location
Current Time
Location
fig.transport-block3
BPM (Tempo)
Tempo Track Switch
Time Signature
Auto Punch button
Auto Punch
In/Out
Loop button
Loop Start/End
Metronome Mode
Loop Quick Set
button
Loop Quick Set
Length
● Launcher Block
fig.launcher-block1
Sampling button
Import button
Instruments button
Audio Phrases
button
Quick Edit button
Pad Banks button
Explanation
The RECORD PARAMETER popup will appear.
The entire length of this bar corresponds to the length of the current song, and the scrollbar handle
indicates the current time location. You can move the current time location by dragging or clicking the
scrollbar handle.
Explanation
This switches the mixdown mode. If you record while this is on, the current song will be mixed down.
Here you can switch the synchronization mode.
This area indicates the current time location in "measures - beats - ticks." You can click a numerical
field and change the time.
This area indicates the current time location in "hours : minutes : seconds . frames."
Explanation
This indicates the tempo at the current time location. If the tempo track is off, you can click this value
and change the tempo.
You can click this area to switch the Tempo Track On (
Display the time signature of the current song.
This button switch the Auto Punch function On/Off.
This area indicates the auto punch-in time (at left) and auto punch-out time (at right). You can click a
numerical field and change the time.
This button switch the Loop function On/Off.
This area indicates the loop-start time (at left) and loop-end time (at right). You can click a numerical
field and change the time.
Specifies when the metronome signal will be output.
This button makes the playback loop from the beginning of the current beat for the length specified
by the Loop Quick Set Length setting.
This indicates the loop length that will be used when you press the Loop Quick Set button. You can
click this to see a list of the available loop lengths.
Explanation
The SAMPLING popup will appear. Here you can make settings and execute sampling.
The IMPORT popup will appear. Here you can import data from the hard disk or a CD.
The INSTRUMENTS popup will appear. Here you can edit or make settings for instruments.
The AUDIO PHRASES popup will appear. Here you can edit or make settings for audio phrases.
Here you can edit the audio phrases or the partials of the current track.
The PAD BANKS popup will appear. Here you can switch the pad bank of the velocity pads.
)/Off ( ).
11