Elation FUZ418 User Manual page 15

G O B O I N S TA L L AT I O N
5. On the gobo wheel module, locate the circuit board on the left-hand side of the gobo wheel
module, directly above the static gobo wheel. On this circuit board, find the 3-pin connector
and the 4-pin connector (denoted by the yellow boxes, above right) located just behind a
bank of three (3) capacitors, and disconnect both of these connectors.
6. Loosen the thumb screws for the gobo wheel module, and carefully slide the gobo wheel
module out of its mounting slots. Place the module on a flat, stable surface in a DUST-FREE,
INDOOR location.
15