0126: Auto Pan - Roland FP-4 Midi Implementation Manual

●0121: Auto Wah
Cyclically controls a filter to create cyclic change in timbre.
No Parameter Value
1 Filter Type 0 - 1 Lpf, Bpf
2 Manual #2 0 - 127 0-127
3 Peak 0 - 127 0-127
4 Sens 0 - 127 0-127
5 Polarity 0 - 1 Up, Down
6 Rate Mode 0 - 1 Hz, note
7 Rate #1 1 - 127 0.05-10.00 Hz
8 Rate 0 - 21 note
9 Depth 0 - 127 0-127
10 Phase 0 - 90 0-180 deg
11 Low Gain 0 - 30 -15- +15 dB
12 High Gain 0 - 30 -15- +15 dB
13 Level 0 - 127 0-127
●0103: Humanizer
Adds a vowel character to the sound, making it similar to a human voice.
No Parameter Value
1 Drive Sw 0 - 1 Off, On
2 Drive #2 0 - 127 0-127
3 Vowel1 0 - 4 a, e, i, o, u
4 Vowel2 0 - 4 a, e, i, o, u
5 Rate Mode 0 - 1 Hz, note
6 Rate 1 - 127 0.05-10.00 Hz
7 Rate #1 0 - 21 note
8 Depth 0 - 127 0-127
9 Input Sync Sw 0 - 1 Off, On
10 Input Sync 0 - 127 0-127
Threshold
11 Manual 0 - 100 0-100
12 Low Gain 0 - 30 -15- +15 dB
13 High Gain 0 - 30 -15- +15 dB
14 Pan 0 - 127 L64-63R
15 Level 0 - 127 0-127
Description
Type of filter
Lpf: The wah effect will be applied
over a wide frequency range.
Bpf: The wah effect will be applied
over a narrow frequency range.
Adjusts the center frequency at
which the effect is applied.
Adjusts the amount of the wah effect
that will occur in the range of the
center frequency.
Set a higher value for Q to narrow the
range to be affected.
Adjusts the sensitivity with which
the filter is controlled.
Sets the direction in which the
frequency will change when the
auto-wah filter is modulated.
Up: The filter will change toward a
higher frequency.
Down: The filter will change toward
a lower frequency.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of modulation (Hz)
Frequency of modulation (note)
Depth of modulation
Adjusts the degree of phase shift of
the left and right sounds when the
wah effect is applied.
Gain of the low range
Gain of the high range
Output Level
Description
Turns Drive on/off.
Degree of distortion
Also changes the volume.
Selects the vowel.
When this is set to "note," the effect is
synchronized with the tempo.
Frequency at which the two vowels
switch (Hz)
Frequency at which the two vowels
switch (note)
Effect depth
Determines whether the LFO for
switching the vowels is reset by the
input signal (ON) or not (OFF).
Volume level at which reset is
applied
Point at which Vowel 1/2 switch
49 or less: Vowel 1 will have a
longer duration.
50: Vowel 1 and 2 will be of equal
duration.
51 or more: Vowel 2 will have a
longer duration.
Gain of the low frequency range
Gain of the high frequency range
Stereo location of the output
Output level
●012b: Ring Modulator
This is an effect that applies amplitude modulation (AM) to the input signal, producing bell-
like sounds. You can also change the modulation frequency in response to changes in the
volume of the sound sent into the effect.
No Parameter Value
1 Frequency #1 0 - 127 0-127
2 Sens 0 - 127 0-127
3 Polarity 0 - 1 Up, Down
4 Low Gain 0 - 30 -15- +15 dB
5 High Gain 0 - 30 -15- +15 dB
6 Balance #2 0 - 100 D100:0W-
D0:100W
7 Level 0 - 127 0-127
●0125: Tremolo
Cyclically modulates the volume to add tremolo effect to the sound.
No Parameter Value
1 Mod Wave 0 - 4 Tri, Sqr, Sin,
Saw1, Saw2
2 Rate Mode 0 - 1 Hz, note
3 Rate #1 1 - 127 0.05-10.00 Hz
4 Rate 0 - 21 note
5 Depth #2 0 - 127 0-127
6 Low Gain 0 - 30 -15- +15 dB
7 High Gain 0 - 30 -15- +15 dB
8 Level 0 - 127 0-127
●0126: Auto Pan
Cyclically modulates the stereo location of the sound.
No Parameter Value
1 Mod Wave 0 - 4 Tri, Sqr, Sin,
Saw1, Saw2
2 Rate Mode 0 - 1 Hz, note
3 Rate #1 1 - 127 0.05-10.00 Hz
4 Rate 0 - 21 note
5 Depth #2 0 - 127 0-127
6 Low Gain 0 - 30 -15- +15 dB
7 High Gain 0 - 30 -15- +15 dB
8 Level 0 - 127 0-127
MIDI Implementation
Description
Adjusts the frequency at which
modulation is applied.
Adjusts the amount of frequency
modulation applied.
Determines whether the frequency
modulation moves towards higher
frequencies (Up) or lower
frequencies (Down).
Gain of the low frequency range
Gain of the high frequency range
Volume balance between the direct
sound (D) and the effect sound (W)
Output level
Description
Modulation Wave
Tri: Triangle wave
Sqr: Square wave
Sin: Sine wave
Saw1/2: Sawtooth wave
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of the change (Hz)
Frequency of the change (note)
Depth to which the effect is applied
Gain of the low range
Gain of the high range
Output Level
Description
Modulation Wave
Tri: triangle wave
Sqr: square wave
Sin: sine wave
Saw1/2: sawtooth wave
When this is set to "note," the effect is
synchronized with the tempo.
Frequency of the change (Hz)
Frequency of the change (note)
Depth to which the effect is applied
Gain of the low range
Gain of the high range
Output Level
21