012B: Ring Modulator; 0125: Tremolo; 0126: Auto Pan; 012C: Slicer - Roland F-120R Implementation Manual

●012b: Ring Modulator
This is an eff ect that applies amplitude modulation (AM) to the input signal,
producing bell-like sounds. You can also change the modulation frequency in
response to changes in the volume of the sound sent into the eff ect.
No Parameter Value
1 Frequency #1 0–127
2 Sens 0–127
3 Polarity 0–1
4 Low Gain 0–30
5 High Gain 0–30
6 Balance #2 0–100
7 Level 0–127
●0125: Tremolo
Cyclically modulates the volume to add tremolo eff ect to the sound.
No Parameter Value
1 Mod Wave 0–4
2 Rate Mode 0–1
3 Rate #1 1–127
4 Rate 0–21
5 Depth #2 0–127
6 Low Gain 0–30
7 High Gain 0–30
8 Level 0–127
●0126: Auto Pan
Cyclically modulates the stereo location of the sound.
No Parameter Value
1 Mod Wave 0–4
2 Rate Mode 0–1
3 Rate #1 1–127
4 Rate 0–21
5 Depth #2 0–127
6 Low Gain 0–30
7 High Gain 0–30
8 Level 0–127
Description
Adjusts the frequency at
0–127
which modulation is applied.
Adjusts the amount of
0–127 frequency modulation
applied.
Determines whether the
frequency modulation moves
Up, Down towards higher frequencies
(Up) or lower frequencies
(Down).
Gain of the low frequency
-15–+15 dB
range
Gain of the high frequency
-15–+15 dB
range
Volume balance between the
D100:0W–
direct sound (D) and the eff ect
D0:100W
sound (W)
0–127 Output level
Description
Modulation Wave
Tri: Triangle wave
Tri, Sqr, Sin,
Sqr: Square wave
Saw1, Saw2
Sin: Sine wave
Saw1/2: Sawtooth wave
When this is set to "note, " the
Hz, note eff ect is synchronized with the
tempo.
0.05-10.00 Hz Frequency of the change (Hz)
Frequency of the change
note
(note)
Depth to which the eff ect is
0–127
applied
-15–+15 dB Gain of the low range
-15–+15 dB Gain of the high range
0–127 Output Level
Description
Modulation Wave
Tri: triangle wave
Tri, Sqr, Sin,
Sqr: square wave
Saw1, Saw2
Sin: sine wave
Saw1/2: sawtooth wave
When this is set to "note, "
Hz, note the eff ect is synchronized
with the tempo.
Frequency of the change
0.05–10.00 Hz
(Hz)
Frequency of the change
note
(note)
Depth to which the eff ect
0–127
is applied
-15–+15 dB Gain of the low range
-15–+15 dB Gain of the high range
0–127 Output Level
●012c: Slicer
By applying successive cuts to the sound, this eff ect turns a conventional sound into
a sound that appears to be played as a backing phrase. This is especially eff ective
when applied to sustain-type sounds.
No Parameter Value
1 Rate Mode 0–1
2 Rate 1–127
3 Rate #1 12–21
4 Attack 0–127
Input Sync
5 0–1
Sw
Input Sync
6 0–127
Threshold
7 Mode 0–1
8 Shuffl e #2 0–127
9 Level 0–127
●0130: Compressor
Flattens out high levels and boosts low levels, smoothing out fl uctuations in volume.
No Parameter Value
1 Attack #2 0–127
2 Threshold #1 0–127
3 Post Gain 0–18
4 Low Gain 0–30
5 High Gain 0–30
6 Level 0–127
MIDI Implementation
Description
When this is set to "note, " the
Hz, note eff ect is synchronized with the
tempo.
Rate at which the 16-step
0.05-10.00 Hz
sequence will cycle (Hz)
Rate at which the 16-step
note
sequence will cycle (note)
Speed at which the level
0–127
changes between steps
Specifi es whether an input
note will cause the sequence
Off , On to resume from the fi rst step
of the sequence (ON) or not
(OFF)
Volume at which an input
0–27
note will be detected
Sets the manner in which the
volume changes as one step
progresses to the next.
Legato: The change in volume
from one step's level to the
next remains unaltered. If the
level of a following step is the
same as the one preceding it,
Legato, Slash
there is no change in volume.
Slash: The level is momentarily
set to 0 before progressing to
the level of the next step. This
change in volume occurs even
if the level of the following
step is the same as the preced-
ing step.
Timing of volume changes for
even-numbered steps (step 2,
0–127 step 4, step 6...).
The higher the value, the later
the beat progresses.
0–127 Output level
Description
Sets the speed at which
0–127
compression starts
Adjusts the volume at which
0–127
compression begins
0–+18 dB Adjusts the output gain.
Gain of the low frequency
-15–+15 dB
range
Gain of the high frequency
-15–+15 dB
range
0–127 Output level
23