Table of Contents
Advertisement
TouchPad board
NOTE:
The TouchPad board spare part kit does not include the TouchPad board cable. The TouchPad board
cable is available using spare part number 830763-001.
Description
TouchPad board
Before removing the TouchPad board, follow these steps:
1.
Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2.
Disconnect the power from the computer by unplugging the power cord from the computer.
3.
Disconnect all external devices from the computer.
4.
Remove the keyboard/top cover (see
Remove the TouchPad board:
1.
Turn the keyboard/top cover upside down with the front toward you.
2.
Remove the four Phillips PM2.0×2.8 screws (1) that secure the TouchPad board bracket
and TouchPad board to the top cover.
3.
Remove the three Phillips PM2.0×2.2 broadhead screws (2) that secure the TouchPad board to
the top cover.
4.
Remove the TouchPad board bracket (3).
5.
Remove the TouchPad board (4) and cable.
Reverse this procedure to install the TouchPad board.
28
Chapter 5 Removal and replacement procedures
Keyboard/top cover on page
Spare part number
837600-001
24).
Advertisement
Table of Contents
