Table of Contents
Advertisement
8.
If it is necessary to replace the display bezel or any of the display assembly subcomponents:
a.
Remove the two display bezel screw covers (1).
The display bezel screw covers are included in the Rubber Kit, spare part numbers 837603-001 (for
use on computer models in sunset red finish) and 837604-001 (for use on computer models in
twinkle black finish).
b.
Remove the two Phillips PM2.0×2.2 broadhead screws (2) that secure the display bezel to
the display assembly.
c.
Flex the inside edges of the top edge (1), the left and right sides (2), and the bottom edge (3) of
the display bezel until the bezel disengages from the display back cover.
d.
Remove the display bezel (4).
The display bezel is available using spare part number 832493-001.
9.
If it is necessary to replace the webcam/microphone module:
a.
Detach the webcam/microphone module (1) from the display back cover. (The webcam/
microphone module is attached to the display back cover with double-sided adhesive at
two locations.)
b.
Disconnect the webcam/microphone module cable (2) from the webcam/microphone module.
44
Chapter 5 Removal and replacement procedures
Advertisement
Table of Contents
