Rimage Amigo II Reference Manual page 3

Front to back alignment
In this sample, the recorder tray is too far forward in relation to the disc and the gripper.
Note: If the recorder tray is too far back, perform the opposite adjustments.
1. Turn the Torx T10 adjustment screws on
each side of the recorder clockwise so that the
recorder can move in.
Note: Turn the adjustment screws ½ turn
at a time.
2. Tighten the Torx T10 recorder screws or the
thumb screws. The recorder moves towards
the rear of the unit and rests on the adjustment
screws.
3. Check the alignment.
•
If the disc is centered on the tray, the
recorder is aligned.
•
If the disc is misaligned, check one of the
following:
Is the misalignment still front to back?
If so, repeat the previous steps.
Is the misalignment diagonal? If so, go
to Diagonal alignment on page 4.
Is the misalignment side to side? If so,
go to Side to side alignment on page
5.
2000094_A
The figure shows a front to back misalignment. The disc
is touching the tray at C, and there is a gap at D.
© 2006, Rimage Corporation
Rimage Producer Family
3