Software Setup - Johnson Controls 300 Series Manual

44 Network Control Module 300 Series Technical Bulletin

Software Setup

Cable connections from the TTM101, TTM102, and TTM103 to the
S2 NCM Port 2 require the following cable:
NCM
9-pin Female
Shell
In
1
In
2
Out
3
Out 4
5
In
6
Out
7
8
In
9
Figure 20: Table Top Modems to Port 2 of the S2 NCM
Several components integrate software and hardware into a system.
• The Software Architecture Technical Bulletin (LIT-636010)
provides an overall guide to objects and attributes.
• NCSETUP for Windows operating system, described in the
NCSETUP for Windows Technical Bulletin (LIT-6360251d),
establishes the NCM's configuration and parameters in the
non-volatile RAM. This information sets the archive data path, the
port designations and values, the program set downloaded to the
NCM, dial-up phone numbers when applicable, and other
parameters.
• The NCM Definition window (Figure 21) identifies the NCM to
the system. The process also correlates non-volatile RAM
parameters, maps, associated graphics, and help screens to the
defined NCM. The Operator Workstation User's Manual describes
how to define hardware objects.
DCD
RXD
TXD
DTR
GND
DSR
RTS
CTS
NC
S2 (TTM)
25-pin Male
Shell
In
2
3 Out
4
In
Out
5
Out
6
7
8 Out
20
In
nc3fig17