Johnson Controls 300 Series Manual page 45

Network Control Module 300 Series Technical Bulletin
Definition Window
Identify the NCM to the system by entering data into the attribute
fields on the Definition window. The figure below shows the window
as seen on the OWS; a description of each attribute follows.
If the Definition window is brought up from an existing object, then all
of the fields are filled in with the data from that object.
Fields that allow the data to be modified have the field value boxed in.
When a field entry is modified, the new value is immediately verified
when the field is exited.
For information on how to define the NCM with Graphic
Programming Language (GPL) or JC-BASIC, refer to the Graphic
Programming Language Programmer's Manual and JC-BASIC
Programmer's Manual.
I tem E dit V iew
HDQTRS
DEVICES
NCM-1
Object Name
NCM-1 IN MECH ROOM
Expanded ID
ENG
NC Language
Graphic Symbol #
0
0
Operating Instr. #
Figure 21: NCM Definition Window
NCM Definition
A ction Go To Accessory
Hardware
1
NC Subnet Address
3
NC Node Address
N2
Port 1 Type
Port 2 Type
9600
NT Baud Rate
H
elp
DEVICES
Port 1 Baud Rate
Port 2 Baud Rate
200tc22
45