Advertisement
Note: The indicator normally appears when the
engine is off and the key switch is turned to the
"ON" position.
Low Voltage Error
(For LZS/LZX EFI Models)
Located on the right console in the message display.
Refer to the Hour Meter User's Guide for more
information.
Deck Lift Pedal
Located at the right front corner of the floor pan.
Push the pedal forward with your foot to raise the
cutting deck. Allow the pedal to move rearward to
lower the cutting deck to the cut height that has been
set.
Deck Lift Switch–Wing Deck Models
Only
Located on the RH console (see Figure 8).
Push the top of button to raise the center deck and
fold up the outer wings.
Push the bottom of button to lower the center deck
and outer wings.
Transport Lock
Located on the height of cut adjustment plates to the
right of the parking brake.
Position in the transport latching position to
automatically latch the cutting deck when raised to
the transport position (see item 1 in Figure 14).
In the non-latching position, the deck will
automatically return to the cutting height when the
pedal is lowered (see item 3 in Figure 14).
1. Latching position
2. Transport lock control
Electronic Control Unit Malfunction
Indicator
(LZE EFI, and LZX Briggs EFI
Units Only)
The malfunction indicator light (MIL) is the light
located in the right console panel–the right light
below the throttle control.
The electronic control unit (ECU) continuously
monitors operation of the EFI system. If a problem
or fault within the system is detected, the MIL
is illuminated. Follow the troubleshooting steps
outlined in the Kohler and Briggs engine operator's
manual if the MIL is illuminated.
Before Operation
Before Operation Safety
• Evaluate the terrain to determine what accessories
and attachments are needed to properly and
safely perform the job. Only use accessories and
attachments approved by Exmark.
• Inspect the area where the machine is to be used
and remove all rocks, toys, sticks, wires, bones,
and other foreign objects. These can be thrown
or interfere with the operation of the machine
and may cause personal injury to the operator or
bystanders.
• This mower was designed for one operator only.
Do not carry passengers.
• Wear appropriate personal protective equipment
such as safety glasses, long pants, substantial
33
Operation
Figure 14
3. Non-latching position
g008608
Advertisement
