Advertisement
Operation
When the alarm sounds, the error message will
display and the LED will turn red.
• Continuous sound indicates critical errors.
• Chirping sound indicates less critical errors, such
as required maintenance or service intervals.
Refer to the RED Equipped User's Guide for
more information.
Brake Lever
Located on right side of unit, just to the front of the
RH motion control lever.
The brake lever engages a parking brake on the drive
wheels.
Note: The LCD indicator appears in the message
display on the RH console when the park brake is
engaged (see Figure 11).
Pull the lever up and rearward to engage the brake.
Push the lever forward and down to disengage the
brake.
The unit must be tied down and brake engaged when
transporting.
Ignition Switch
Located on right console.
The ignition switch is used to start and stop the
engine. The switch has three positions "OFF", "ON"
and "START". Insert key into switch and rotate
clockwise to the "ON" position. Rotate clockwise to
the next position to engage the starter (key must be
held against spring pressure in this position). Allow
the key to return to the "on" position immediately
after the engine starts.
Figure 10
1. Off
2. On
g008610
3. Start
Note: Brake must be engaged, motion control
levers out (neutral lock position) and PTO switch
disengaged to start engine. (It is not necessary for the
operator to be in the seat to start the engine.)
Note: The LCD indicators appear when each control
meets the "safe to start" mode (e.g. the indicator
turns on when the operator is in the seat.)
Note: RED Equipped Models Only: The system
will allow the unit to start with the PTO switch in
the pulled out (up) position, but will not engage the
blades. The PTO engagement switch must be reset
to engage the PTO.
Hour Meter
(For all LZE Models, all LZS/LZX
Kawasaki Models, and all Briggs
Models Except RED Equipped
Models)
Located on the right console in the message display
(reference Figure 6 ).
The hour meter records the number of hours that
the engine has run.
1. LCD Indicators
2. Low fuel indicator light
3. Fuel level bar display
4. Low voltage indicator light
5. Hour/Voltage display
The hour meter is recording when the decimal point
is flashing in Hour/Voltage display.
Hours are displayed when the key is off or when the
machine is running.
Note: If the ignition key is turned to the "ON"
position for a few seconds before cranking the engine,
30
Figure 11
g008612
Advertisement
