Fine Magnification - Ricoh 480W Operating Instructions Manual

G G G G
Enter the length for "Copy: Verti-
cal" using the number keys, and
then press [#].
Note
❒ To change a length, press the
key you want to change, and
then enter the new value.
H H H H
Press [OK].
I I I I
Select paper tray.

Fine Magnification

For environment reasons such as hu-
mid conditions, paper may expand or
shrink. This can result in a mismatch
between the size of the original and
copy. This function uses the measure-
ments of the original and the copy to
calculate a ratio to produce copies
that are close to the actual size.
Preparation
Measure the length and width of
the original and the copy, and then
calculate the correction ratio as fol-
lows:
Calculating the Correction Value (%)
Example)
Original
Horiz.
To copy at the same size as the original
... For the example above:
Set the correction value (horizontal) to 0.8%.
Copy
Horiz.
correction value(%)
ZEDG010E
Note
❒ Fine Magnification is used for orig-
i na ls t ha t h av e a lre a d y b e e n
scanned. If you want to apply fine
magnification corrections to paper
that has stretched due to the paper
type or exposure to humid condi-
tions, see "Fine Ratio Adjustment:
Copier", General Settings Guide.
A A A A
Press [Reduce / Enlarge].
B B B B
Press [Fine Magnificatn.].
C C C C
Adjust the horizontal ratio using
o ] and [n n ].
[o o o n n
D D D D
Adjust the vertical ratio using
o ] and [n o o n ]. n n
[o
Note
❒ To change the value, press [Clear],
and then enter the new one.
E E E E
Press [OK].
Copier Functions
2
41