Ricoh 480W Operating Instructions Manual page 42

Copying
Sample Copy
Use this function to check the copy
settings before making a long copy
run.
Preparation
Select [Press Start Key] under Feed
2
Start Method in System Settings.
You cannot make sample copy
when [Auto] is selected. See "Feed
Start Method", General Settings
Guide.
Note
❒ This function can be used only
when the Sort function is selected.
A A A A
Select [Sort] and make any other
necessary settings, and then place
the originals.
B B B B
Press the { { { { Sample Copy} } } } key.
One copy set is delivered as a sam-
ple.
C C C C
If the sample is acceptable, press
[Print].
The specified number of copies is
made, minus one for the sample
copy.
34
Note
❒ If you press [Suspend] after
checking the results, return to
A
step
tings as necessary. Depending
on the combination of func-
tions, you may not be able to
change certain settings.
Changing the number of sets
You can change the number of copy
sets during copying.
Note
❒ This function can only be used
when the Sort function is selected.
A A A A
While "
Copying...
press the { { { { Clear/Stop} } } } key.
B B B B
Press [Change Quantity].
C C C C
Enter the number of copy sets us-
ing the number keys, and then
press the { { { { #} } } } key.
Note
❒ The number of sets you can en-
ter differs depending on when
the { { { { Clear/Stop} } } } key is pressed.
D D D D
Press [Continue].
AHD104S
Copying starts again.
to adjust the copy set-
" is displayed,