Raymarine SL72 Owner's Handbook Manual page 220

Appendix B: Using the Auxiliary Junction Box
Raystar 114 Combined GPS and Differential Beacon
Receiver
To connect your Raystar 114 Combined GPS and Differential Beacon
Receiver to your display, cut off the 5-pin connector, strip back the insulation
on all the wires and connect to the Auxiliary Junction Box as shown in the
illustration below.
CAUTION:
Ensure the correct polarity of the 12 V supply before applying display or
SeaTalk power. It is recommended that a multimeter is used to check the
connections.
Note: You can use the GPS Set-Up page to manually tune the Raystar 114. Re-
fer to Chapter 6 for details.
To Display Unit
SeaTalk Socket
Black
12V
Power
Supply
(fused) Red
B-5
Black From
White
Combined
Red
GPS/DBR
Yellow
sensor
Green
D4301_1