Raymarine SL72 Owner's Handbook Manual page 183

8-16
1 Securing nut 2 Gland 3 Inter-unit cable 4 Eight-way plug 5 Eight-way socket 6 Power cores
7 Terminal clamp 8 Screwdriver 9 Earthing clamp 10 Top clamp 11 Clamp screws
Figure 8-9:
7. Connect the 8-way plug (4) to the connector (5). The correct fitting is with
the small arrow marked on the body of the plug facing upwards and to the
left hand side. The grey wire will then be at the left hand side and the white
wire will be at the right hand side.
8. Connect the red "+"and black "-" power cores (6).
Connect the red cable lead to one of the terminal sockets marked "+", and
the black cable lead to one of the sockets marked "-".
The terminal clamps (7) are operated using a screwdriver (8), as shown in
the inset diagram on Figure 8-9.
9. Secure the nut (1) on the watertight gland, making sure that it grips the
cable's outer sheath.
10.Secure the cable with the top clamp (10), using the two screws (11) pro-
vided. Ensure that the clamp goes around the exposed wire braid, and that
the wire braid makes contact with the earthing clamp. Tighten the screws
until the top clamp deforms just enough to contact the lower earthing
clamp (see inset).
SL72 & SL72RC PLUS Pathfinder Radar & Radar/Chartplotter
Fitting the Inter-unit Cable to the Scanner