Removing A Chart Card; Displaying The Chart Data - Raymarine SL72 Owner's Handbook Manual

Chapter 5: Standard Chart Operations (SL72RC PLUS only)
Figure 5-1:

Removing a Chart Card

We recommend that before you remove a chart cartridge, you ensure the chart
is not being used on any other display unit. Removing a chart cartridge whilst
a display unit is accessing the chart may cause an operational error.
➤ To remove a chart card:
1. Open the card cover, at the lower left of the display front panel.
2. Press on the card you wish to remove, and move the top of the card to the
left to clear the retaining pegs.
The card will spring half-way out, enabling you to grip the card and
remove it from the slot.
3. Remember to close the card cover so that it clicks shut, to prevent water
from entering the card reader assembly.

Displaying the Chart Data

The new chart information will be displayed when you move the cursor into an
area covered by the new chart or, if it is already in the area, change the range
scale.
The boundary of each chart digitized in the current card is defined by a box or
rectangle. (You can switch off the chart boundaries display if you wish, as part
of the chartplotter set up described in Section 7.6.)
Removing the Chart Card
5-3
D4158-1