Cursor Echo - Raymarine SL72 Owner's Handbook Manual

Chapter 6: Further Chart Operations (SL72RC PLUS only)
➤ To cancel the MOB, press and hold the MARKS key for 2 seconds.
The chart is re-drawn at its previous scale, and the MOB symbol and data box
MARKS
are removed.
Note: The MOB procedure can also be initiated or cancelled if the appropri-
ate SeaTalk message is received by the display unit.

6.5 Cursor Echo

In a combined radar/chart display you can set the display to enable cursor
echo. Cursor echo (accessed from System Set Up, described in Section 7.3)
enables you to display a radar cursor on the chart picture, or a chart cursor on
the radar picture.
The following options can be toggled ON or OFF :
• Radar Cursor In: displays the cursor from another radar on the chart dis-
play or chart window (default - OFF ).
• Chart Cursor In: displays the cursor from another or chartplotter on the
radar display or radar window (default - OFF ).
• SeaTalk Cursor Out: enables the output, onto SeaTalk, of the display's
own cursor (default - OFF ).
• Cursor Echo Local: echoes the cursor position between open windows on
the same display (default - ON ).
If you set the options to OFF , no cursor echo information is displayed.
When the appropriate option is switched on, the display shows its own cursor,
plus the cursor of the other display with appropriate cursor text ( RDR or CHT ) to
indicate its origin. This means that you could move the cursor over a target on
the radar display, and check the identity of the target by looking at the radar
cursor position on the chartplotter.
6-7