Raymarine SL72 Owner's Handbook Manual page 37

2-4
Chart Mode - SL72RC PLUS only
➤ To switch the display on, press and hold the POWER key until the unit beeps.
If the display was last used in chartplotter mode, the keys light up and the
Raychart graphic is displayed, followed by the caution:
CAUTION:
Raychart chart displays are based on cartographic data that
C-MAP believes to be accurate. However, you should not rely on these
displays as your primary source of navigation. Rather, your Raychart
should be used only as a backup to official government charts and
traditional methods of navigation.
When you have read and understood the caution, press the CONTINUE soft key.
The chart is displayed.
If this is the first time the chartplotter has been turned on, and no chart card is
installed, the display shows the small-scale world map and the default soft
keys. Otherwise, the display shows the selected chart area and any data that
were displayed when the display was last used.
Until unit beeps
Figure 2-3:
Switch Off
➤ To switch the scanner and display unit off, press and hold the POWER key for
three seconds. A countdown timer is displayed as shown below:
SL72 & SL72RC PLUS Pathfinder Radar & Radar/Chartplotter
Switch On - Chart Mode
D4277-2