Table of Contents
Advertisement
Chapter 4: Setting Up
Chapter 4: Setting Up
4.1 Introduction
When you have installed your system and are familiar with its basic
operation, you may wish to set it up to operate according to your
requirements and display information according to your preferences.
This is achieved using the function controls which are displayed when the
PAGE key is pressed. These settings can be changed at any time.
When your preferences are set, they maintain until they are reset and are
retained even when the unit is powered off.
This chapter covers the following topics:
•
•
The set up parameters are selected via three soft keys:
•
•
•
Note: The additional TRACK SET UP function is covered in Chapter 3:Op-
eration.
This section provides instructions for displaying and changing the
factory default values to your preferences. The following sections list the
parameters with their possible settings and describe the function of each
parameter in turn.
4.2 System Set Up Parameters
➤
To set the System default parameters:
1. From chart mode, with no function bar displayed, press the PAGE key
2. Use trackpad left/right to highlight SYSTEM SET UP and press ENTER
System parameters and default settings.
Chartplotter-specific parameters and default settings.
System Set Up: controlling overall functionality.
Chart Set Up: controlling the chartplotter functions, including way-
point information and vectors.
GPS Set Up: displaying the Raystar 120 GPS receiver status.
to display the SET UP function bar (Figure 4-1):
Figure 4-1: Set Up Function Bar
to display the System Set Up menu (Figure 4-2):
4-1
D4694_1
Hide quick links:
Advertisement
Table of Contents
