Clearing The Current Route From The Screen; Retrieving A Route From The Database - Raymarine Raychart 425 Owner's Handbook Manual

3-12
4. Press ENTER to save the route. Press ENTER again (in response to the
When naming a route, use the trackpad to move the cursor right or left to
the character to be edited. Use trackpad up/down to scroll through the
characters or numerals. The name can contain up to eight alphanumeric
characters, including spaces.
5. Press ENTER to finish and clear the Route List, then press CLEAR to

Clearing the Current Route from the Screen

To clear the current route from the screen, select CLEAR ROUTE . If the
current route has not been saved, you are prompted to save it.
➤
To clear the current route from the screen:
1. Select ROUTES or place the cursor over a route leg until the leg data is
2. Select CLEAR ROUTE and press ENTER to clear the route or press
3. If the route has not been saved, a prompt gives the options ENTER to
4. To save the route in the database, press ENTER . The Name Route

Retrieving a Route from the Database

A route from the database list can be selected as the current route. The list
is accessed from the second set of ROUTES functions.
➤
To select a route as the current route:
1. Select ROUTES , followed by MORE , then ROUTE LIST . The route list is
2. Select SHOW ROUTE . The route list is removed and the selected route
prompt) to name the route or CLEAR to save as the default ROUTE XX ,
where XX is the next available number.
return to the chart mode.
displayed in the Status Bar.
CLEAR to cancel the operation.
save or CLEAR to remove the route from the screen.
functions are displayed, see Saving the Current Route on page 3-11.
displayed with the currently selected route highlighted (Figure 3-21.
is shown on screen as the current route.
Raychart 425 Chartplotter