St6000 & St7000 Autopilot Connections; Mounting The Bulkhead Socket - Raymarine ST600R Owner's Handbook Manual

56
Note: The hand held socket can be installed anywhere on the SeaTalk bus.
1. Apply the template to the bulkhead as required.
2. Drill the 18mm (45/64in) clearance hole and the two 2.4mm
3. Remove the template.
4. Fit the plug cap (1) to the socket body (2) as shown.
5. Cut and strip the SeaTalk cable (not supplied - refer to table).
6. Pass the cables through the bulkhead and wire to the socket, making
ST6000 & ST7000 Autopilot Connections
ST6000
Course Computer

6.3 Mounting the Bulkhead Socket

(3/32in) pilot holes.
sure the wires are connected to the correct pins.
ST7000
Screen
(SeaTalk ground)
Yellow
(SeaTalk Data)
ST600R Autopilot Control Unit
Red
(+12v)
Pin
Identification
Stripes