Table of Contents
Advertisement
11 Function check
May only be carried out by qualified personnel.
A function check must be made when the installation is finished and before the machine can be ready to be used.
Whenever a repair has been made, a function check must be performed before the machine can be used again.
Check the automatic stop of the machine
• Start the machine.
• Check if the micro switches are working properly:
The machine must stop if the door is opened.
Check the direction of rotation (only on machines with 3–phase power supply, marine installation)
Demount the top panel and start a program. Check that the drum rotation is clockwise.
If the direction is wrong, swap two of the three phases to the left on the connection terminal.
Check the heat
• Let the machine work for five minutes on a program with heat.
• Check that the heating is working by opening the door and feel if there is heat in the drum.
Ready to use
If all tests are OK the machine is now ready to be used.
If some of the tests failed, or deficiencies or errors are detected, please contact your local service organisation or
dealer.
Installation manual
39
fig.6311
fig.7119
Advertisement
Table of Contents
