Husqvarna FC 450 2019 Owner's Manual page 50

10 TUNING THE CHASSIS
48
Main work
–
–
–
–
–
H01189-10
–
–
–
–
–
Finishing work
–
https://www.motorcycle-manual.com/
1
Remove screws . Take off the handlebar clamp. Remove
the handlebar and lay it to one side.
Info
Cover the components to protect them against dam-
age.
Do not kink the cables and lines.
2
Remove screws . Take off handlebar supports
4
Position rubber bushings
below.
Place the handlebar supports in the required position.
Info
The handlebar supports are longer and higher on one
side.
Position the left and right handlebar supports evenly.
2
Mount and tighten screws
Guideline
Screw, handle- M10
bar support
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
Position the handlebar clamp.
1
Mount screws but do not tighten yet.
First bolt the handlebar clamp with screws
longer, higher side of the handlebar supports so that both
parts touch.
Guideline
Screw, handlebar M8
clamp
1
Tighten screws evenly.
Guideline
Screw, handlebar M8
clamp
Mount the handlebar cushion.
3
.
5
and push through nuts from
.
40 Nm (29.5 lbf ft)
®
Loctite 243™
1
onto the
20 Nm (14.8 lbf ft)
20 Nm (14.8 lbf ft)