17 SERVICE WORK ON THE ENGINE
126
–
–
K01072-10
–
K01073-10
–
–
–
K01074-10
–
–
–
–
K01073-11
–
–
401955-12
–
https://www.motorcycle-manual.com/
Mount and tighten screw plug
Guideline
Screw plug, oil
M20x1.5
screen
Mount and tighten oil drain plug
new seal ring.
Guideline
Oil drain plug with
M12x1.5
magnet
5
Remove screws
. Remove the oil filter cover with the O-
ring.
6
Pull oil filter
out of the oil filter housing.
Lock ring plier (51012011000)
Completely drain the engine oil.
Thoroughly clean the parts and sealing surfaces.
Lay the motorcycle on its side and fill the oil filter housing to
about ⅓ full with engine oil.
Place the oil filter into the housing.
Lubricate the O-ring of the oil filter cover and mount it with
7
the oil filter cover
.
Mount and tighten screws.
Guideline
Screw, oil filter cover
M6
Stand the motorcycle upright.
8
Remove filler plug
from the clutch cover together with the
O-ring, and fill up with engine oil.
Engine oil
1.20 l
(1.27 qt.)
Info
Too little engine oil or poor-quality engine oil will result
in premature wear of the engine.
Mount and tighten the filler plug together with the O-ring.
3
with the O-ring.
15 Nm (11.1 lbf ft)
1
with the magnet and a
20 Nm (14.8 lbf ft)
10 Nm (7.4 lbf ft)
Engine oil
(SAE 10W/50)
(
p. 145)