Technical Specifications - BEA LZR-MICROSCAN1UT Manual

Stand-alone, door-mounted, safety sensor system for automatic swing doors

Hide thumbs

Table Of Contents

Table of Contents

TECHNICAL SPECIFICATIONS

Technology:

Detection mode:

Detection width:

Mounting Height:

Remission factor:

Angular resolution:

Testbody:

Emission characteristics:

IR laser:

Supply Voltage:

Power Consumption:

Response time:

Output:

Rating:

Test:

Rating:

Temperature Range:

Degree of Protection:

Humidity:

Vibrations:

Material:

Norm Conformity:

Mounting angle (rotational):

Tilt angle:

Pollution on front screens:

For version compatibiltiy serial number information, please see Application Note 76.0017 or contact BEA for technical support.

BEA, INC. INSTALLATION/SERVICE COMPLIANCE EXPECTATIONS

BEA, Inc., the sensor manufacturer, cannot be held responsible for incorrect installations or incorrect adjustments of the sensor/device; therefore, BEA,

Inc. does not guarantee any use of the sensor/device outside of its intended purpose.

BEA, Inc. strongly recommends that installation and service technicians be AAADM-certifi ed for pedestrian doors, IDA-certifi ed for doors/gates, and

factory-trained for the type of door/gate system.

Installers and service personnel are responsible for executing a risk assessment following each installation/service performed, ensuring that the sensor/

device system performance is compliant with local, national, and international regulations, codes, and standards.

Once installation or service work is complete, a safety inspection of the door/gate shall be performed per the door/gate manufacturer's recommendations

and/or per AAADM/ANSI/DASMA guidelines (where applicable) for best industry practices. Safety inspections must be performed during each service

call – examples of these safety inspections can be found on an AAADM safety information label (e.g. ANSI/DASMA 102, ANSI/DASMA 107, UL294,

UL325, and International Building Code).

Verify that all appropriate industry signage, warning labels, and placards are in place.

Page 2 of 16

laser, time-of-flight measurement

presence

20 – 48"

(measured from leading edge to sensor LED)

75 – 98"

(measured from finished floor to sensor LED)

> 2%