Jacuzzi J-485 Owner's Manual page 82

J-400
22. ProClarity/ProClear Filter Reminder: This message
will appear when the filter reminder time has expired
(Figure 15.0d). Remove the ProClarity/Proclear filters
and filter/debris bag for cleaning or replacement.
23. ProClarity Depth Filter Reminder: This message will
appear when the filter reminder time has expired
(Figure 15.0e). The ProClarity Depth filter must be
replaced.
24. Water Refresh Reminder: This message will
appear when the "Water Refresh" timer has expired
(Figure 15.0f). The water needs to be drained and
refilled with fresh water.
25. Extended Temperature Activated: The spa is set
to go up to 104°F (40°C), but it can be set to reach 106°F (41°C).
To access the extended temperature you need press and hold
your finger over the temperature reading for about 5 seconds. The
temperature reading will start to blink to indicate the system is ready.
Tap to raise the temperature up to 106°F (41°C).
Note: The heater icon
active.
WARNING:
!
CAUSING SEVERE INJURY, BURNS, WELTS OR DEATH!
Water temperature in excess of 104°F (40°C) may be injuri-
ous to your health.
76
will be blinking to indicate that the feature is
RISK OF HYPERTHERMIA (OVER-HEATING)
Reminder
It's time to clean or replace
your ProClarity and Pro-
Clear filters. Contact your
authorized dealer if new
filters are needed.
reset snooze
Figure 15.0d
Reminder
It's time to replace your
ProClarity Depth filter.
Contact your authorized
dealer for a new filter.
reset snooze
Figure 15.0e
Reminder
This is a general
reminder. Please change
your water soon.
reset snooze
Figure 15.0f