System Event Log (Sel); Sensor Data Record (Sdr) - Fortinet FortiGate-7030E System Manual

FortiGate-7030E System Management Module
Description
by resetting the a comlog start
location in flash (reset_loc) or
erasing all of the flash storage
(chip_erase). Available on the
passive module.
Disable a module's comlog.
Available on the passive
module.
Enable comlog. Available on
the passive module.
Set comlog baud rate.
<speed> can be 9600, 19200,
38400,57600, 115200, or
expressed as level 1 to 4.
Available on the passive
module.

System event log (SEL)

The SMC in each module generates system event log (SEL) messages that record system events as they occur. All SEL
messages are stored by individual FIM and FPM module SMCs. They are also all collected and stored by the SMM
SMC. From the SMM you can use the following commands from the active or passive SMM to view and clear SEL
messages.
Operation
Display the local SEL for a
module.
Clear the local SEL.
Get SEL information.
Get SEL time
Set SEL time

Sensor data record (SDR)

The sensor data record (SDR) contains static information about the sensors in each chassis module. Information
includes the Sensor ID string, sensor type, sensor event/reading type, entity id, entity instance, sensor unit, reading
FortiGate-7030E 6.2.3 System Guide
SMC CLI Commands
comlog disable
comlog enable
comlog setbaud <speed>
SMC CLI Commands
sel <slot>
sel clear
N/A
time get
time set <yyyy/mm/dd
hh:mm:ss>
Fortinet Technologies Inc.
IPMI commands
fortinetoem comlog clear
fortinetoem comlog clear
fortinetoem comlog setbaud
<speed>
IPMI Commands
sel list
sel elist
-v sel list
sel clear
sel info
sel time get
sel time set
47