Table of Contents
Advertisement
FortiGate-7030E hardware assembly and rack mounting
To insert FIM and FPM modules, see the guide supplied with the module.
FIM-7920E front panel
Status, Alarm
HA, and Power
LEDS
10/100/1000BASE-T Copper
Power
Power
Slider
Button
FIM-7920E
USB
NMI
Secure
Button
Screw
Module
Lever
FortiGate-7030E 6.2.3 System Guide
MGMT1 - MGMT4
Management Interface
M1 and M2 10GigE Base
Channel SFP+ Interfaces
(heartbeat and management)
You must carefully slide the module all the way into the chassis slot, close the module levers
to seat the module into the slot, and tighten the secure screws to make sure the module is
fully engaged with the backplane and secured. You must also make sure that the power
sliders are fully closed by gently pushing them down.
Installation Highlights :
1. Module levers must be closed.
2. Secure screws must be tightened.
3. Power sliders must be fully closed for the module to get power and start up.
If the module is not receiving power all LEDs remain off.
All FIM and FPM-7000 series modules must be protected from static discharge and physical
shock. Only handle or work with these boards at a static-free workstation. Always wear a
grounded electrostatic discharge (ESD) preventive wrist strap when handling these boards.
C1 to C4
100GigE Fabric Channel
QSFP28 Network
Interfaces (data)
Fortinet Technologies Inc.
Power
Slider
Module
Secure
Lever
Screw
23
Advertisement
Table of Contents
