Table of Contents
Advertisement
Installing Firmware with Firmware Loader
1.
Open Firmware Loader to establish a connection between the computer and the device.
The
Add Device...
Figure 39.
2.
Select
3.
Select the method of connection from the
4.
Depending on the connection method, additional options appear. Make the appropriate
selections for the current connection method.
5.
Click the
6.
Click
Browse
7.
On the
and click the
ATTENTION:
other extension is not a irmware upgrade for this device and could cause the
device to stop functioning.
ATTENTION : Les ichiers irmware valides doivent contenir l'extension ichier S19.
Un ichier avec n'importe quelle autre extension n'est pas une mise à jour de
irmware pour cet appareil et l'appareil pourrait arrêter de fonctionner.
8.
Click
Add
listed in the Firmware Loader main window.
9.
Click
Begin
10.
Close Firmware Loader when the
Progress
NOTE: See the
dialog box opens.
Add Device... Window
from the
FOX T UWP 302
Device Name
button.
Connect
in the
New File Firmware (Optional)
window, navigate to the new firmware file, which has an .S19 extension,
Open
button.
Open
Valid irmware iles must have the ile extension .S19. A ile with any
. The
dialog box closes and the device and firmware are
Add Device...
to start the upload process.
Remaining Time
column shows
, and the
100%
Factory reset
page 14 for reset information.
FOX T UWP 302 Wallplate Transmitter • Reference Information
drop-down list.
Connection Method
panel. The
field shows
field shows
Status
completed
SIS commands on page 22 or
drop-down list.
window opens.
Open
, the
00.00.00
.
System Reset
on
44
Advertisement
Table of Contents
