PREPARATIONS
Connect power cable
Note:
Check that the mains voltage on the type plate (on the bottom of the
device) corresponds to your local mains supply. If this is not the case,
contact your specialist dealer.
Plug the mains cable into the socket (230 V~, 50/60 Hz).
1
AL 1
AL 2
WEC
NAP
M
Note:
ON/OFF
PROJECTOR
1/6
The only way to disconnect the device from the mains supply is to pull
out the plug.
Connect projector
Plug the jack of the projector cable into the socket »
1
device) with the arrow pointing forwards.
AL 1
AL 2
ON/OFF
____________________________________
« (left side of the
21