Table of Contents
Advertisement
Quick Links
ENGLISH
O
E
CLO
ALARM
10
SAFETY, INFORMATION
Safety
This device is designed for the playback of audio signals.
Any other use is expressly prohibited.
Protect the device from moisture (water drops or splashes). Do not place any
vessels such as vases on the device. These may be knocked over and spill
fluid on the electrical components, thus presenting a safety risk.
When deciding where to place the device, please note that furniture surfa-
ces are covered by various types of varnish and plastic, most of which con-
tain chemical additives. These additives can corrode the device supports,
leaving residues on the furniture surfaces which can be difficult or impossi-
ble to remove.
Do not use any cleaning agent, as this may damage the casing. Clean the
device with a clean, moist leather cloth. Never open the device casing. The
manufacturer will not accept any liability for damage resulting from impro-
per handling.
The type plate is located on the bottom of the device.
Information
This device is noise-suppressed according to the applicable EU directives.
This product fulfils the European directives 89/336/EEC, 73/23/EEC and
93/68/EEC.
This device conforms to the safety regulation VDE 0860 and therefore the
international safety regulation IEC 65.
Technical data
Power supply:
Max. power consumption:
Output:
Frequency bands:
Dimensions and weight:
Environmental note
As little material as possible was used in the packaging of your device.
It consists of two separate materials: cardboard (box) and polyethylene
(bag). Please observe the local regulations for disposing of the packing
material.
Technical and design modifications reserved.
230 V, 50 Hz
<3 W (operation), <2 W (standby)
DIN 45324, 10% THD 400 mW
(for SC 3300)
FM 87.5 ...108.0 MHz
MW 526.5 ...1606.5 kHz
(for SC 3340 LW) FM 87.5 ... 108.0 MHz
LW 148.5 ... 283.5 kHz
W x H x L 182 x 63 x 136 mm
Weight approx. 0.6 kg
_____________________
Advertisement
Table of Contents
Related Manuals for Grundig Sonoclock SC 3300
Summary of Contents for Grundig Sonoclock SC 3300
-
Page 1: Technical Data
SAFETY, INFORMATION _____________________ ENGLISH Safety This device is designed for the playback of audio signals. Any other use is expressly prohibited. Protect the device from moisture (water drops or splashes). Do not place any vessels such as vases on the device. These may be knocked over and spill fluid on the electrical components, thus presenting a safety risk. - Page 2 OVERVIEW ___________________________________________ ALARM Controls on the top Interrupts the alarm function. Stops the sleep timer. SNOOZE Press and hold down to activate the time setting. TIME Press and hold down to activate the alarm setting. ALARM Press briefly to cancel the alarm standby. Displays the alarm time (in standby mode).
-
Page 3: The Display
OVERVIEW ____________________________________ Controls on the sides • The slide switch on the left side of the device switches RADIO e ALARM the radio on or to standby. In alarm mode, it switches between the signal tone and the radio station. Adjusts the volume (on right side of device). -
Page 4: Power Supply
POWER SUPPLY ___________________________________ Mains operation Note: Check that the mains voltage on the type plate (on the bottom of the device) corresponds to your local mains supply. If this is not the case, contact your specialist dealer. Plug the mains cable into the socket (230V~, 50 Hz). ALARM Note: The only way to disconnect the device from the mains supply is to pull... -
Page 5: Additional Information For Units Sold In The Uk
“E”, earth symbol “ ”, coloured green, or green & yel- low. Replacement mains lead sets can be obtained from your local dealer, or by contacting Grundig Consumer Relations (01788 570088) Moulded 3-pin lead set, suitable for UK use: Ref: Leadset UK 8290-991-224... -
Page 6: Setting The Clock
SETTINGS __________________________ Setting the clock When you switch on the device for the first time, the time flashes in the display to indicate that you must set the clock. The same thing applies after a power failure, or if the device has been plugged out and no back-up battery is inserted. -
Page 7: Radio Operation
OPERATION __________________________________________ Switching on and off • »RADIO ALARM« to switch the device on and off. Radio operation For the best FM (VHF) reception, it is sufficient to direct the wire antenna accordingly. Tuning radio stations Set the frequency band with »MW FM«... -
Page 8: Timer Mode
OPERATION _______________________________________________ Interrupting the alarm Press »SNOOZE« while the alarm is sounding. – The alarm (signal tone or radio) stops. – The alarm goes on again at 9-minute intervals (the total alarm time is 1 hour and 59 minutes). Cancelling the alarm for the day Press »ALARM«...