Table of Contents
Advertisement
Binary I/O Menu
Communication Menu
The Communication menu is used for changing and adapting communication settings for the mainboard and
the communication modules in the device. The menu follows a usability (for example, request for acceptance
after leaving certain menu levels).
NOTE
i
i
Enter settings for communication modules only through DIGSI 5.
Device Functions Menu
Test & Diagnosis Menu
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018
The settings are grouped in corresponding submenus according to their
assignment to existing function groups (for example, line 1).
You will find information about viewing and changing settings in chapter
8.4.1
General.
Selecting the Binary I/O menu provides you with the option to see the
routing to the binary inputs, binary outputs and signals displayed.
You can find more information in chapter
Status.
The Communication menu notifies you about the status of configured
communication modules (module type, slot, port and IP address). Further-
more, you can, for example, also change the IP address of your device.
Via the Device functions menu, you can set the operating modes of the
device or of individual functions (for example, test), initiate resetting of
stored LEDs and binary outputs, change passwords and make regional
settings (date and time, display formats).
The Test & Diagnosis menu offers you support during commissioning and
testing. If you wish to test systems and equipment on site, you can read all
necessary information from the corresponding submenus and start actions
such as device reset.
You can find more information on this in chapter
Using On-Site Operation Panel
5.5 Menu Tree
5.8 Display of Routings and
10.5 Test and
Diagnostics.
81
Advertisement
Table of Contents
