Setting A Marker; Assignment Of Authorizations With Confirmation Id - Siemens SIPROTEC 5 V7.80 Operation

[scstatus-090413-01.tif, 1, en_US]
Figure 8-71
The meaning of the status columns is as follows:
AB = Acquisition blocking active (acquisition blocking for the switching device is set)
MU = Manual update (switching device was manually updated)
CH = Chatter blocking active (Chatter blocking has been activated and is still set)
8.9.9

Setting a Marker

In order to be able to set a marker manually with a device operation, you must activate a cross in the Control
Menu column in the DIGSI 5 information matrix (see
[scrangma-090413-01.tif, 1, en_US]
Figure 8-72
The marker appears in a list, for example, under
Commands → Additional → Display or → Status.
At this point you can observe or vary the current status.
NOTE
i
i
To change the state of a marker (from On to Off or vice versa), you need to enter the confirmation ID for
control.

Assignment of Authorizations with Confirmation ID

8.9.10
Authorization for sensitive operations in the on-site operation panel is done by the assignment of confirmation
IDs (see also chapter
Figure 8-73 shows an example of a device without a key switch. For devices with key switches, the confirma-
tion IDs are not required for non-interlocked switching and for the switching authority. These are replaced by
the corresponding key switches for non-interlocked control and for local switching authority.
SIPROTEC 5, Operation, Manual
C53000-G5040-C003-9, Edition 06.2018
Status Display of Switching Devices
Routing of a Marker to the Operating Menu
11.4 Confirmation ID).
Figure 8-72).
Operation in the Operating State
8.9 Control System on Site
187