Pch Configuration; Pch Storage Configuration - Asus WS X299 SAGE/10G User Manual

3.6.4

PCH Configuration

The items in this menu allow you to adjust the PCH PCI Express speed.
PCI Express Configuration
This item allows you to configure the PCI Express slots.
PCIe Speed
This item allows your system to automatically select the PCI Express port speed.
Configuration options: [Auto] [Gen1 (2.5 GT/s)] [Gen2 (5 GT/s)] [Gen3 (8 GT/s)]
3.6.5

PCH Storage Configuration

While entering Setup, the BIOS automatically detects the presence of SATA devices. The
SATA Port items show Not Present if no SATA device is installed to the corresponding SATA
port.
SATA Controller(s)
This item allows you to enable or disable the SATA Device.
Configuration options: [Disabled] [Enabled]
SATA Mode Selection
This item allows you to set the SATA configuration.
[AHCI]
[Intel RST Premium
(RAID)]
SMART Status Check
SMART (Self-Monitoring, Analysis and Reporting Technology) is a monitoring system that
shows a warning message during POST (Power-on Self Test) when an error occurs in the
hard disks.
Configuration options: [On] [Off]
SATA6G_1 - SATA6G_8
SATA6G_1 - SATA6G_8
This item allows you to enable or disable the selected SATA port.
Configuration options: [Disabled] [Enabled]
Hot Plug
These items appears only when the SATA Mode Selection is set to [AHCI] and allows
you to enable or disable SATA Hot Plug Support.
Configuration options: [Disabled] [Enabled]
ASUS WS X299 SAGE/10G
Set to [AHCI] when you want the SATA hard disk drives
to use the AHCI (Advanced Host Controller Interface).
The AHCI allows the onboard storage driver to enable
advanced Serial ATA features that increases storage
performance on random workloads by allowing the drive to
internally optimize the order of commands.
Set to [Intel RST Premium (RAID)] when you want to create
a RAID configuration from the SATA hard disk drives.
3-17