Advertisement
Main Circuit Terminals
Terminal
R/L1, S/L2, T/L3
U/T1, V/T2, W/T3
B1, B2
+1, +2
+1, –
(2 terminals)
Control Circuit Terminals
The figure below shows the control circuit terminal arrangement.
There are two DIP switches, S1 and S3, located on the control board
SW1
Switches analog input A1 between voltage and current input
Used to select sourcing (PNP)/sinking (NPN, default) mode for the digital inputs (PNP requires
SW3
external 24 Vdc power supply)
Control Circuit Terminal Functions
Type
No.
S1
Multi-
to
Multi-function digital input 1 to 5
Function
S5
Digital
Inputs
SC
Multi-function input common
A1
Analog input
Analog
+V
Analog input power supply
Input
AC
Frequency reference common
Multi-
MA N.O. (fault)
Function
MB
N.C. output (fault)
Relay
MC
Digital output common
Output
Monitor
AM Analog monitor output
Output
AC
Monitor common
I80E-EN
J1000 Quick Start Guide
Type
Main circuit power sup-
ply input
Drive output
Braking resistor
DC reactor connection
DC power supply input For connecting a DC power supply.
Ground Terminal
S1
S2
S3
S4
S5
Terminal Name (Signal)
Connects line power to the drive.
Drives with single-phase 200 V input power use terminals R/L1
and S/L2 only (T/L3 is not used).
Connects to the motor.
For connecting a braking resistor.
Linked at shipment. Remove the link to install a DC choke.
For 200 V class: Ground with 100 Ω or less
For 400 V class: Ground with 10 Ω or less
MA
SC
A1 +V
AC AM AC
Function (Signal Level), Default Setting
Photocoupler inputs, 24 Vdc, 8 mA
Note: Drive preset to sinking mode (NPN). When using
source mode, set DIP switch S3 to "SOURCE" and use an
external 24 Vdc (±10%) power supply.
Sequence common
0 to +10 Vdc (20 kΩ) resolution 1/1000
0/4 to 20 mA (250 Ω) resolution: 1/500
+10.5 V (max allowable current 20 mA)
0 V
Digital relay output
30 Vdc, 10 mA to 1 A
250 Vac, 10 mA to 1 A
0 to 10 Vdc (2 mA or less), Resolution: 1/256 (8 bit)
0 V
3 Electrical Installation
Function
MB
MC
Use a straght-edge screwdriver
with a blade width of max 2.5 mm
and a thickness of max 0.6 mm to
release the terminals
15
Advertisement
