Table of Contents
Advertisement
Access the appliance from your web browser using the https://VMA-ENVR1-8P-<serial number> or
l
https://VMA-ENVR1-8P8B-<serial number>.
Use the Address Resolution Protocol (ARP) to determine the IP address for the device:
l
1. Locate and copy down the MAC Address (MAC) listed on the Serial Number Tag for reference.
2. Open a Command Prompt window and enter the following command:
arp -a
3. Scroll through the response and look for the IP address corresponding to the MAC address.
Discover the DHCP-assigned IP address from the ACC Client software:
l
1. Download and install and open the ACC Client software on to the configuration laptop. For
information see
2. Log into the site that uses this naming convention: VMA-ENVR1-8Px-<serial number> or VMA-
ENVR1-8P8B-<serial number>.
Note: The username and password for the Web Interface application is separate from
the administrator username and password for the ACC Server.
3. Display the server Setup tab.
4. Open a web browser and enter the IP address in this format: https://<IP address>.
5. Continue the remaining steps for installing the appliance.
If none of the above suggestions resolve the problem, contact Avigilon Technical Support.
Network Configuration
By default, the ACC ES 8 Port Appliance acquires an IP address on the network through DHCP. If you need
to set up the ACC ES 8 Port Appliance to use a static IP address or any specific network configuration, see
Connecting the Device to Users and Cameras on page 14
Checking System Health
You can check on the health of the system components in the Site Health in the ACC Client software. See
Site Health
in the ACC Client User Guide for more information.
Network Configuration
Installing and Starting the ACC Client on
page 18.
for more information.
8
Advertisement
Table of Contents
