Table of Contents
Advertisement
monitor video through the ACC Client software connect to the device through this network.
Important: Before adding the appliance as a new ACC site, or merging the appliance to an existing
ACC Site, first set its IP address. It is highly recommended to be in the same IP subnet as the other
servers in the ACC Site.
The camera network is a closed network that typically only contains cameras. This reduces the amount of
interference with video recording.
When connecting an ONVIF device to the camera network, configure it to use the appliance as its time / NTP
server if the appliance is running ACC 7.x or later.
For more information about the network connections, see
You can perform any of the following actions in each of the panes in the Network panel:
To...
Do this...
Set how the
In each of the panes in the Network panel, toggle Automatic IP on to discover
device obtains an
connected networks automatically (the default setting), or off to manually specify the
IP address for
connections. Enter the appropriate values in the following fields if you are manually
each network.
entering the connection settings:
Click Apply to save your changes.
Set how the
Toggle Automatic DNS on to discover connected DNS servers automatically (the
device obtains a
default setting), or off to manually specify the DNS servers. Controls to add and
named address
delete addresses in the list, and reorder them are activated when Automatic DNS is
from a DNS
toggled off.
server.
Assigning a PoE Power Budget
Use the PoE panel to see how much power is available to, and being used by, connected devices. The
default setting for all ports is Auto. This setting automatically detects and budgets the amount of power
required by the device connected to the port. For each port you can adjust this setting manually, or turn off
power output completely. If you want to manually adjust the power output of the ports you must calculate a
PoE power budget, see
Tip: If you are using a midspan PoE power injector for cameras that require high power PoE, you
Assigning a PoE Power Budget
IP Address
l
Subnet Mask
l
Default Gateway
l
Budgeting PoE Power on
page 23.
Supported Network Configurations on
page 4.
15
Advertisement
Table of Contents
