E2J70BD_EN.book Page 82 Friday, June 29, 2007 2:50 PM
Dynamic Range Control (Default: ON) (DVD
only)
Set to "ON" to make the dynamic range narrower.
Select a setting using [U \ D], then
press [ENTER/OK].
Dynamic Range Control
ON
OFF
Your setting is activated.
The Dynamic Range Control function is effective
only with analogue audio connection.
Note
• The Dynamic Range Control function is available
only on discs recorded in the Dolby Digital format.
PCM sampling (Default: 48kHz)
Select a setting using [U \ D], then
press [ENTER/OK].
PCM
48kHz
96kHz
Your setting is activated.
48kHz:
If your amplifier / decoder is NOT
compatible with 96 kHz PCM, select
"48kHz". Sound recorded at 96 kHz is
down sampled to 48 kHz.
96kHz:
If your amplifier / decoder is compatible
with 96 kHz PCM, select "96kHz". Sound
is sampled at 96 kHz.
Note
When playing back a disc with copyright protection:
• Even if you select "96kHz", the sound is down
sampled to 48 kHz.
Dolby Digital conversion (Default: Stream)
Select a setting using [U \ D], then
press [ENTER/OK].
Dolby Digital
PCM
Stream
Your setting is activated.
PCM:
Converts the Dolby Digital into PCM
(2 channel).
If your amplifier / decoder is NOT
compatible with Dolby Digital, set to
"PCM".
Stream:
Outputs Dolby Digital signals.
If your amplifier / decoder is compatible
with Dolby Digital, set to "Stream".
Hint
When playing back a DVD-RW disc recorded in VR
mode:
• If the audio source on a disc is in Dolby Digital
format, set "Dolby Digital" to "PCM" so that you can
switch to main audio (L), sub audio (R), or a
combination of both (L / R) using your amplifier /
decoder.
82
EN
Settings for MPEG (Default: PCM) (DVD only)
Select a setting using [U \ D], then
press [ENTER/OK].
MPEG
PCM
Stream
Your setting is activated.
PCM:
Converts MPEG into PCM.
If your amplifier / decoder is NOT
compatible with MPEG, set to "PCM".
Stream:
Outputs MPEG Audio signals.
If your amplifier / decoder is compatible
with MPEG, set to "Stream".
Settings for DTS (Default: ON) (DVD only)
Select a setting using [U \ D], then
press [ENTER/OK].
DTS
ON
OFF
Your setting is activated.
ON:
Outputs DTS signals.
If your amplifier / decoder is compatible
with DTS, set to "ON".
OFF:
No DTS signal is output.
If your amplifier / decoder is NOT
compatible with DTS, set to "OFF".
3. Disc Menu Language (Default: English)
(DVD only)
Set the Disc Menu language.
Select a setting using [U \ D], then
press [ENTER/OK].
Disc Menu Language
English
Other
Your setting is activated.
4. Audio Language (Default: Original)
(DVD only)
Set the Audio language.
Select a setting using [U \ D], then
press [ENTER/OK].
Audio Language
Original
English
Other
Your setting is activated.
If "Original" is selected, the audio language is the
default of the inserted disc.